Throttle Valve Linkage Adjust

1. Remove cruise control rod on vehicles equipped with cruise control.

2. Disconnect throttle valve linkage from throttle assembly.

3. Loosen locknut on pump rod, then shorten rod by rotating several turns.

4. Rotate throttle lever assembly to full throttle position and secure in this position.

5. Lengthen pump rod by rotating in opposite direction as described in step 3 until injection pump lever contacts full throttle stop.

6. Release throttle lever assembly and tighten pump rod locknut.

7. Disconnect pump rod from throttle lever assembly.

8. Connect throttle valve linkage to throttle assembly.

9. Depress metal locking tab on upper end of cable and hold in this position.

10. Position slider through fitting and away from lever assembly until slider contacts metal fitting.

11. Release metal tab, then rotate throttle lever assembly to full throttle position and release.

12. Connect pump rod to lever assembly, then connect cruise control throttle rod, if equipped.

13. On models equipped with cruise control, adjust servo throttle rod until minimum amount of slack is present Install clip into first hole closest to bellcrank that is within servo ball.