Power Antenna - Relay Replacement
84olds3
SUBJECT POWER ANTENNA RELAY REPLACEMENT NUMBER: 84-T-4
DATE: January 30, 1984
MODELS/YEARS 1979-84 TORONADO; 1977-84 CUTLASS
SUPREME, 88 & 98; 1981-82 OMEGA SECTION: 9
CONDITION
When it becomes necessary to replace power antenna relays with part numbers 22510577, 556511 or 550893, a power antenna relay kit, part no.. 22524833 should be used. This kit contains a mini relay, an adapter harness, and one four-way connector body. The relay kit replaces the original metal covered relays used on the following vehicles:
TORONADO:
1979-84 Toronado
CUTLASS:
88-98:
1977-84 Cutlass, 88 and 98
1981-82 Omega
CORRECTION
Install the relay kit as follows:
1. Remove the failed relay.
2. Remove the staggered 3-way connector body from the power antenna wiring by releasing the secondary terminal locks and remove three (3) terminals and wires from the connector.
3. Install the above terminals into the four-way connector body, part no. 8917542 (furnished with the jumper harness) as follows:
Cavity A - Dk. Green
Cavity B - Gray
Cavity C - White
Cavity D - Blank
Close the secondary lock latch and inspect for proper terminal engagement.
4. Plug one end of the jumper harness into the new relay, part no. 10030273 (2 connectors). Plug the other end onto the IP harness and the converted power antenna lead. Refer to the appropriate illustration.
5. Tape relay to IP harness in a horizontal or terminal down position so that it is rattle free.
6. Check power antenna operation.
PARTS INFORMATION
The following part numbers are included in the power antenna relay kit, part number 22524833:
1 Mini Relay P/N 10030273
1 Adapter Harness P/N 12038466
1 Connector Body P/N 8917542
NOTE: FUTURE RELAY REPLACEMENT, AFTER KIT INSTALLATION, WILL ONLY REQUIRE REPLACEMENT OF THE RELAY, PART NO. 10030273, OR EQUIVALENT.
WARRANTY INFORMATION
Power antenna relay kits installed under warranty must be submitted using the following information.
Trouble Operation Labor
Failed P/N Code Number Hours
22524833 92 R0620 0.3