Disassembly

Fig. 12, Input shaft components, removal:

Refer to Fig. 12, and proceed as follows:
A hydraulic press, tools J-36183 and J-36184 are required to conduct the following procedure. Also, identify blocker ring (14) for the 3rd gear and blocker ring (7) for the 4th gear. Do not interchange the 3rd and 4th gear blocker rings.

1. Remove snap ring (2).
2. Using tools described previously, remove gears (3) and (4), bearings (5), race (6), blocker ring (7 and 14), synchronizer assembly (8) and gear (15).
3. Remove 3rd gear bearing (16).

Inspection
Inspect all components for excessive wear and/or damaged. Replace worn or damaged components as required.