Manual Window

REGULATOR TAPE







REMOVE OR DISCONNECT
1. Trim panel and water deflector.
2. Safety belt retractor.
3. Regulator.
4. Separate block from guide by placing a flat-bladed into the slot and pushing downward.
5. Block from tape.
6. Slide guide and sash from regulator.
7. Tape from tabs on regulator and wind handle to remove tape from regulator.

INSTALL OR CONNECT
1. Cut replacement tape to length.
2. Tape end into regulator and wind handle to drive tape into regulator.
3. Attach end of tape to tabs on regulator.
4. Raise guide above end of tape. Assemble block to guide by pushing guide downward.
5. Regulator to door.
6. Two sash bolts and adjust glass.
7. Safety belt retractor.
8. Water deflector and trim panel.