With Pulse

Try the following checks before performing other diagnosis.

1. Check the WPR Fuse by visual inspection.
2. If the Wiper Motor runs but the wiper blades do not, check the wiper linkage at the wiper crank arm.
3. Check that Wiper Switch Assembly connector C206 is mated correctly.
4. If the Washer does not opeate, check that:
- Washer reservoir is filled.
- Hoses are not pinched or kinked.
- Hoses are correctly attached.
- Nozzles are not clogged.
5. Check that ground G112 (L4 VIN R) or G105 (V6 VIN N) is clean and tight.
6. If the Wipers do not operate in MIST or LO and cycle in and out of the Park position in HI, check YEL (196) wire for an open (see schematic).