Ignition Lock Cylinder
Fig. 6 Ignition Key Alarm/buzzer Assembly Removal:
Fig. 7 Ignition Key Lock Cylinder Removal:
1. Refer to steps 1 through 9 in TURN SIGNAL SWITCH.
2. Remove key lock cylinder set, then remove alarm/buzzer assembly and clip, Fig. 6.
3. Reinsert key in lock cylinder and turn key to the LOCK position.
4. Remove lock retaining screws and lock cylinder, Fig. 7.
5. Reverse procedure to install, noting that key is in the RUN position when installing alarm/buzzer assembly.