Silhouette Model

1. Remove old upper transaxle oil cooler hose clamp and hose assembly.

2. Install new upper transaxle oil cooler hose assembly to transaxle finger tight (constant tension clamp is supplied on hose assembly).

3. Tighten fitting at transaxle to 23 NM (16 lb. ft.).

4. Push hose onto cooler tube (at radiator) until hose end touches tube stop.

5. Position clamp within 8 mm (0.3 in.) from end of hose and install with Kent-Moore clamp pliers JA1487. Clamp placement is critical, improper location can cause leaks.

Caution:
Safety glasses must be worn when installing spring loaded clamps. A compressed spring could be propelled toward face possibly causing eye injury.

Notice:
Be certain that clamp is placed in pliers correctly. Pliers should not come in contact with sides of clamp. Clamp should not be compressed beyond the stop tab. Improper installation can distort clamp and cause leaks.

6. Insure pipe is located properly in transaxle support bracket slot and designed retainers.

7. Check and refill transaxle as necessary. Use only Dexron III Automatic Transmission Fluid. Start vehicle and check for fluid leaks.

8. Install a Campaign Identification Label.