Coupe

Door Lock Module:

Remove or Disconnect

1. Door trim panel.
2. Water deflector loosen.
3. Nut and screw securing cover assembly to door.
4. Door handle cover assembly.
5. Lock cylinder to lock rod.
6. Outside handle to lock rod.
7. Screws securing lock assembly to door.
8. Rivets securing lock module assembly to door by pun ching out mandrel, then using a 4.8 mm (3/16 inch) drill bit.
9. Power lock connector, if equipped.
10. Lock module assembly.

Install or Connect

1. Lock module assembly in position through access hole in door inner panel. Align module to boles in door facing.

NOTICE: It is required that while performing step 2 the lock assembly be held tight against door facing while instal in screws. All screws must be driven at a 90° angle to door facing to prevent cross threading or stripping of screws or door lock attaching holes. It is also required to tight en screws to specified torque of 7 N.m (62 lb. in.).

2. Screws securing lock assembly to door.

Tighten
^ Screws to 7 N.m (62 lb. in.).

3. Power lock connector, if removed.
4. Rivets securing lock module assembly to door using 3116 mcli x 1/4 inch peel type rivets.
5. Outside handle to lock rod.
6. Lock cylinder to lock rod.

Inspect
^ Lock system for proper operation.

7. Door handle cover assembly.
8. Nut and screw securing cover assembly to door.

Tighten
^ Nut to 3 N.m (27 lb. in.).
^ Screw to 2 N.m (18 lb. in.).

9. Water deflector.
10. Door trim panel.