Sedan

Power Switch Assembly Removal:

Remove or Disconnect

1. Switch plate assembly from armrest trim panel.
A. Insert screwdriver 9 mm (3/8 inch) into rear of assembly.
B. Press screwdriver upward and forward to disengage metal spring clip while pulling slightly upward on assembly.
C. Pull assembly rearward to disengage tab on front edge of switch assembly.
2. Retainers from connectors.
3. Connectors from switch plate assembly.
4. Cable from bezel assembly by loosening set screw, if equipped.

Install or Connect

1. Cable to bezel assembly, if equipped. Tighten set screw to secure.
2. Connectors to switch plate assembly.
3. Retainers to connectors.
4. Switch plate assembly to armrest trim panel.
A. Insert forward edge.
B. Press firmly to engage clips.