Troubleshooting Hints - Gauges Cluster

Note: Perform before beginning System Diagnosis

1. Check CLUST Fuse. If open, check CKT 750 for short to ground.
2. Check INDIC Fuse. If open, check CKT 39 for short to ground.
3. Check any inoperative indicator bulb.
4. Make sure grounds G108, G119 and G200 are clean and tight.

^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check.
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.