Test A: Connector C1 Pinout Test

A: Connector C1 Pinout Test (Part 1 Of 2):

A: Connector C1 Pinout Test (Part 2 Of 2):

^ Instrument cluster connector C1: Disconnected.
^ Make all voltage measurements with ignition switch in "RUN" unless otherwise indicated.
^ Make all resistance measurements to ground with ignition switch in "LOCK" unless otherwise indicated.
^ Measure to ground unless another terminal is given.
^ If any measurement is incorrect check wiring for an open or short to ground; Check applicable in-line connectors (see schematic) for proper terminal contact
^ If all checks and measurements are correct check instrument cluster connector for proper terminal contact; If Ok, replace instrument cluster. Repeat system check.