General

COPYING IGNITION KEY ASSEMBLY

PASS-Key II Interrogator J35628:

TOOL REQUIRED:
- J 35628-A VATS/PASS Interrogator

To copy an ignition key, it is necessary to first determine which PASS-Key II key code (resistance value) is needed. The ignition key being copied must be tested to determine the key code. The ignition key may be tested using J 35628-A. To use J 35628-A, turn the tool on, make sure the tool wiring connectors are disconnected and insert the ignition key into the tool lock cylinder. The "Key Code Reader" will display the key code of the ignition key. Obtain an ignition key blank matching this key code and cut it to match the original ignition key.