Alternator: Service and Repair

Engine Generator Mounting (L47):

Generator Cable Routing (L47):

REMOVE OR DISCONNECT
1. Rear seat cushion.
2. Negative battery cable.
3. Upper radiator shroud.
4. Right and left cooling fans.
5. Accessory drive belt from P/S pulley then generator.
6. Top alternator bolts, disconnect cable and regulator connector.
7. Ground strap and P/S line bracket to gain access.
8. Lower generator bolts (raise vehicle).
9. Lower radiator hose (drain radiator).
10. Air inlet duct.
11. Generator through top left side of engine compartment.

INSTALL OR CONNECT
1. Generator through top left side of engine compartment.
2. Air inlet duct.
3. Lower radiator hose.
4. Lower generator bolts.
5. Ground strap and P/S line bracket.
6. Generator Mounting Bolts.
Tighten
^ Front Studs to 38 N.m (28 lb. ft.).
^ Rear Bolts to 47 N.m (35 lb. ft.).
7. Generator Output Terminal Nut.
Tighten
^ Nut to 20 N.m (15 lb. ft.).
8. Voltage regulator connection.
9. Accessory drive belt.
10. Right and left cooling fans.
11. Upper radiator shroud.
12. Negative battery cable.
13. Rear seat cushion.
14. Fill cooling system.