Blower Motor Resistor: Service and Repair

Blower Resistor Assembly:

Remove or Disconnect

1. Negative battery cable.
2. Rear engine sight shield. Refer to Engine Cover Replacement Service and Repair.
3. Center bolt and positive booster cable from multi-use relay and fuse bracket.
4. Underhood fuse blocks and relays from bracket and position aside.
5. Nuts attaching multi-use relay and fuse bracket to front of dash, and bracket from vehicle.
6. CPA and connector from blower resistor assembly.
7. Screws attaching blower resistor assembly to heater and A/C module assembly.
8. Blower resistor assembly from vehicle.

Install or Connect

1. Screws attaching blower resistor assembly to heater and A/C module assembly after positioning in vehicle.

Tighten
- Screws to 1.4 N.m (12 lb. in.).

2. Connector to blower resistor assembly and CAP.
3. Nuts attaching multi-use relay and fuse bracket to front of dash after positioning on vehicle.

Tighten
- Nuts to 3.8 N.m (34 lb. in.).

4. Position fuse blocks and relays to bracket and snap m.
5. Center bolt attaching positive booster cable to multi-use relay and fuse bracket after positioning cable.

Tighten
- Bolt to 10 N.m (89 lb. in.).

6. Rear engine sight shield. Refer to Engine Cover Replacement Service and Repair.
7. Negative battery cable.

Tighten
- Negative battery cable to 15 N.m (11 lb. ft.).