Left

REMOVAL PROCEDURE

IMPORTANT: Note the position of the fasteners prior to removal. Install the fasteners in the same locations. Vehicles vary in the locations of the fasteners and in the quantity of fasteners.

1. Remove the sound insulator screws (2) from the IP.
2. Remove the wing nuts from the studs on the cowl.
3. Remove the Data Link Connector (DLC) (6).
4. Remove the courtesy lamp (4).
5. Remove the fuse panel.
6. Remove the turn signal flasher (7).
7. Remove the left sound insulator (5).

INSTALLATION PROCEDURE
1. Install the Data Link Connector (DLC) (6) to the sound insulator (5).
2. Install the turn signal flasher (7).
3. Install the fuse panel (8).

IMPORTANT: In order to avoid binding of the accelerator or brake pedals, ensure that the sound insulator has proper clearance.

4. Install the courtesy lamp (4). Perform the following steps:
4.1. Position the sound insulator under the dash.
4.2. Insert the cowl studs through the holes in the front of the insulator.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

5. Install the sound insulator screws to the IP.

Tighten
Tighten the fasteners to 1.9 Nm (17 lb in).

6. Install the wing nuts to the studs on the cowl.