Power Mirror Switch: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the trim panel retaining fasteners from the lower armrest bezel.
3. Remove the lower armrest bezel. Use a thin-bladed tool.
4. Disengage the switch plate retainer clips.
Insert a small, flat-blade tool between the switch plate and the trim panel.
5. Lift the switch plate.
6. Disconnect the electrical connectors.
7. Remove the setscrew.
8. Remove the mirror switch.

INSTALLATION PROCEDURE
1. Install the mirror control switch to the switch plate.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

2. Install the setscrew.

Tighten
Tighten the setscrew to 0.8 N.m (7 lb in).

3. Connect the electrical connectors.
4. Install the switch plate in the trim panel. Push inward the switch plate.
5. Install the trim panel retaining fasteners.
6. Connect the negative battery cable.