Sunroof Wiring Harness Replacement
REMOVAL PROCEDURE1. Place the sunshade in the full forward position.
2. Remove the headlining trim finish panel.
3. Disconnect the electrical connector from the following components:
3.1. The sunroof control switch
3.2. The sunroof express module
3.3. The sunroof actuator
IMPORTANT:
^ Note the location of the wiring harness.
^ Note the location of the tie-straps that secure the harness to the drive cables and to the sunroof module.
4. Remove the wiring harness from the sunroof.
INSTALLATION PROCEDURE
1. Install the wiring harness to the sunroof.
2. Connect the electrical connector to the following components:
2.1. The sunroof control switch
2.2. The sunroof express module
2.3. The sunroof actuator
3. Install the headlining trim finish panel.
4. Inspect the sunroof for proper operation.