Ignition Control Module: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the Ignition Control Module electrical connector.
2. Remove the beauty cover (1). Lift at the end opposite the module to release the clip retainer from the ball pin on the cassette. Then slide the cover out of the slide latch in the module.
3. Remove the 4 Ignition Control module to coil cassette mounting screws.
4. Lift the module straight up off of the cassette.
5. Check that the mating connector and seal came off with the module. If not, remove the mating connector and seal from the cassette. (with the mating connector removed, the cassette will have a female connector cavity with male pins).

INSTALLATION PROCEDURE

IMPORTANT: When replacing the Ignition Control module, use the following recommended procedures:
^ Ensure that the mating connector and seal are removed from the coil cassette.
^ When installing a new module, insert the mating connector into the module, install the seal and apply dielectric grease to the terminals on the mating connector prior to installing in the cassette.
^ Check all connectors for damaged terminals.
^ Clean all mounting surfaces before re-installing components.

1. Install the Ignition Control module onto the coil cassette.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the 4 Ignition Control module to coil cassette mounting screws.

Tighten
Tighten the mounting screws to 0.8 N.m (7.1 Lb. in.)

3. Install the beauty cover. Slide the latch tongue into the module while holding the opposite end slightly away from the coil cassette surface in order to clear and align the ball pin on the cassette with the clip retainer on the beauty cover. Press the clip retainer down onto the ball pin.
4. Connect the Ignition Control Module electrical connector.