Hood Open Assist Rod Replacement

Hood Open Assist Rod Replacement

Removal Procedure






Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1. Open and support the hood.
2. Lift up the retainer clips on the assist rod using a small flat-bladed tool.






Notice: Refer to Liftgate/Hood Assist Rod Notice in Service Precautions.

3. Pull the upper end of the assist rod from the ball joint on the hood.
4. Pull the lower end of the assist rod from the ball joint on the lower hood hinge.

Installation Procedure




1. Press the upper end of the assist rods on to the ball joint on the hood.




2. Press the lower end of the assist rods on to the ball joint on the lower hood hinge
3. Remove the support from the hood.
4. Close the hood.