Arming the Ctd System

Use the following procedure in order to arm the system:
1. Place the shift lever in IP (park).
2. Turn OFF the ignition.
3. Open any door.

IMPORTANT: The system is not armed if the doors are locked manually, the power door lock switch or keyless entry transmitter must be used to arm the CTD system.

4. Lock the doors with the power door lock switch or the LOCK button on the transmitter. The system is in standby mode and will not start the arming timer until all doors are closed.
5. The system will arm approximately 30 seconds from the time that the last door is closed. This delay is shown by the theft LED indicator ON STEADY. When the indicator transitions to OFF, the system is armed. After the theft LED indicator transitions to OFF, the theft LED will begin to flash slowly.