Oil Level Sensor: Service and Repair
ENGINE OIL LEVEL SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Raise and support the vehicle.
2. Drain the oil from the oil pan.
3. Disconnect the electrical connector from the oil level sensor.
4. Remove the retainer bolt from the oil pan.
5. Remove the oil level sensor from the oil pan.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the oil level sensor to the oil pan with the retainer bolt.
Tighten
Tighten the bolt to 16 N.m (12 lb ft).
2. Connect the electrical connector to the oil level sensor.
3. Lower the vehicle.
4. Add oil to the proper level.