Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the air cleaner outlet resonator.
2. Remove the accelerator cable bracket.
3. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
4. Remove the MAP sensor (2) from the intake manifold.
5. Inspect the seal for damage.
IMPORTANT: If the MAP sensor seal is damaged, the MAP sensor must be replaced.
INSTALLATION PROCEDURE
1. Install the MAP sensor (2) into the intake manifold.
IMPORTANT: Use the new MAP sensor seal provided with the new MAP sensor.
2. Connect the MAP sensor harness connector.
3. Install the accelerator cable bracket.
4. Install the air cleaner outlet resonator.