Mirror Replacement - Power Mirror

Mirror Replacement - Power

Removal Procedure





1. Remove the upper door trim panel (1) located above the door trim panel.

1. Use the J-tool to release retainer at the top of the panel.
2. Lift the panel up to remove.
3. Disconnect the wire harness from the tweeter.

2. Remove the sound barrier.
3. Remove the door trim panel to gain access to the power mirror wire harness. Refer to Trim Panel Replacement - Side Front Door (Service and Repair) .
4. Disconnect the electrical connector.




5. Remove the mirror fasteners.
6. Disconnect the wire harness from the retainer clip and unseat the grommet.
7. Remove the mirror from the door.
8. Pull the wiring harness through the hole in the mirror patch.



Installation Procedure





1. Route the mirror wiring harness through the hole in the mirror patch.
2. Install the mirror into the door frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the mirror fasteners.

Tighten the mirror fasteners to 9 N.m (80 lb in).

4. Install the grommet by gently pulling into place.
5. Connect the electrical connectors.
6. Install the mirror wire harness into retainer clip.
7. Install the sound barrier.
8. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair) .




9. Install the upper door trim panel (1).

1. Connect the wire harness to the tweeter.
2. Insert the tabs into the slots on the door trim.
3. Push the x-mas tree retainer into the door.