89. Valve Rocker Arm Cover Installation - Right

Valve Rocker Arm Cover Installation - Right





1. Install the valve rocker arm cover gasket into the valve rocker arm cover.
2. Apply sealer GM P/N United States 12345739, GM P/N Canada 10953541 or the equivalent to the notches where the cylinder head and intake manifold meet.
3. Install the valve rocker arm cover.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the valve rocker arm cover bolts.
Tighten the valve rocker arm cover bolts to 10 Nm (89 inch lbs.).





5. Install the vacuum lines from the upper intake manifold.





6. Install the ignition coil studs.
Tighten the ignition coil studs to 25 Nm (18 ft. lbs.).
7. Install the electronic ignition control module.
8. Install the electronic ignition control module nuts and bolts.
Tighten the electronic ignition control module nuts and bolts to 25 Nm (18 ft. lbs.).