Ignition Switch

Ignition Switch Replacement

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system.
2. Remove the upper and lower trim covers.





3. Remove the wire harness assembly (4) from the wire harness strap (5).
4. Remove the wire harness straps (3) from the wire harness assembly (4).
5. Remove the wire harness strap (2) from the upper tilt head assembly (1).





6. Slide the turn signal switch assembly connectors (2) out from the bulk head connector (1).





7. Pull the PASSKEY III (2) off of the ignition lock cylinder case (1).





8. Remove the key alarm connector (1) from the ignition lock cylinder case (2).
9. Remove the 2 tapping screws from the ignition switch assembly (3).

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the ignition switch assembly (3) onto the ignition lock cylinder case (2) and secure by using the 2 tapping screws.
Tighten the screws to 4.7 Nm (42 inch lbs.).
2. Install the key alarm connector (1) into the ignition lock cylinder case (2).





3. Slide the PASSKEYS III (2) onto the ignition lock cylinder case (1).





4. Slide the turn signal switch assembly connectors (2) to the bulkhead connector (1).

Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.





5. Install the wire harness assembly (4) into the wire harness strap (5).
6. Install the wire harness strap (2) into the steering column tilt head assembly (1).
7. Install the wire harness straps (3) onto the wire harness assembly (4).
8. Install the upper and lower trim covers.
9. Enable the SIR system.