Garage Door Opener Replacement

GARAGE DOOR OPENER REPLACEMENT

REMOVAL PROCEDURE




1. Using a flat-bladed tool, pry open the garage door opener panel.
2. Remove the screws from the garage door module.




3. Disconnect the electrical connector from the garage door opener.
4. Remove the button and module assembly from the overhead console.

INSTALLATION PROCEDURE
1. Install the button and module assembly to the overhead console.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Align the module and the screw into the overhead console.

Tighten
Tighten the screws to 8 N.m (71 lb in).

3. Connect the electrical connector to the garage door module.




4. Close the garage door panel to the overhead console.