Manual Transmission/Transaxle: Service and Repair

Fig. 17 Removing anti-rotational link:

EXCEPT MODELS W/4-105 ENGINE
1. Disconnect battery ground cable.
2. Raise and support vehicle and install suitable engine support fixture.
3. Disconnect gearshift linkage and clutch cable from transaxle.
4. Remove front wheel and tire assemblies.
5. Remove left front splash shield, then the impact bracket from transaxle if so equipped.
6. Refer to "Driveshafts, Replace" to disconnect driveshafts.
7. Support transaxle and remove upper clutch housing bolts.
8. Remove left engine mount from transaxle noting location of bolts.
9. Remove anti-rotational link.
10. Move engine and transaxle toward left side of vehicle until mainshaft clears clutch and lower and remove transaxle.
11. Reverse procedure to install. When installing left engine mount, refer to "Engine mounts" section.