11A Fault Code 35 Radiator Fan Relay Control

1. With diagnostic read-out tool connected to engine test connector, connect voltmeter between dark blue/pink wire of radiator fan relay small 3 way connector and ground.
2. Place system in ATM test mode code 04.
3. If voltmeter reading is within one volt of battery voltage and is not cycling, proceed to step B. 11B Radiator Fan Relay Control Circuit
4. If voltmeter reading is cycling between 0 and 5 volts, proceed to step C. 11C Radiator Fan Relay Pull In Coil Windings
5. If voltmeter is not cycling and reads 0 to 1 volt, disconnect logic module white electrical connector. If voltmeter reading is now within 1 volt of battery voltage, replace logic module. If voltmeter reading is still not within 1 volt of battery voltage, check dark blue/pink wire for short circuit to ground.