Special Tools

1 P 201 Engine holder
2 P 201 b Toothed element and mounting parts

Applying Engine Holder/Special Tool P 201



1. Unscrew the top dead center sensor before mounting engine holder on engine.
2. Mount engine holder on studs of right crankcase section. Right side looking forward in car = engine oil cooler side.




1 P 209 a Holder - Bolt crankshaft on holder with bolts, Part No.928102 151 01
2 Circlip pliers - Standard tool
3 VW202 Puller
4 P 221 Compressor (connecting rods)
5 P 222 Compressor (timing chain)
6 P 216 Seal pulling in tool (pulley end)
7 9126 Seal thrust pad (flywheel end)
8 P 238 a Flywheel installer
9 Screwdriver socket - Standard tool
10 9236 Pulley holder





1 Reamer guide rod 35 x 1500 mm - Standard (Hunger)
2 Tap wrench, size 4 - Standard (Hunger)
3 Main bearing reamer - Standard (Hunger)
4 End bearing sleeve EL 35 - Standard (Hunger)
5 Internal calipers with measuring ring 65.000 mm dia. - Standard
6 Wrench, size 58 - Standard (Hunger)
7 Guiding fixture to support guide rod - Standard (Hunger)