Shift Linkage: Adjustments

- Loosen selector rod clamp. Turn selector rod for transmission' 5 inner selector lever left in idle to stop (as seen in driving direction).
- Move selector lever in idle position so that the lower part of the selector lever is vertical and on right stop (3rd and 4th gear).
- Tighten selector rod clamp slightly.
- Check if shift travel is just as large in 1st through 4th gears and if reverse is easy to engage. Correct adjustments if necessary.
- Tighten hex nut on clamp to: 25 Nm (18.4 ft lb)