Remote Control, Audio - Stereo
Only I 01Using the system tester, it is possible to set the alarm system in accordance with the equipment installed and legislation in the countries concerned.
In the case of vehicles without immobilizer and therefore also without remote control units, the alarm system must be set to "remote control off'.
In the case of vehicles with immobilizers, the alarm system must be encoded in accordance with the C number of the country.
For the following C numbers, the alarm system must be set to "remote control on":
00, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 26, 27, 28, 31, 32 and 99.
For the following C numbers, the alarm system must be set to "remote control on light flashing": 02, 23, 24 and 36.
Indicated on display
Remote control
On Workshop *
1=set
return: N
The status which has been set (on or off) appears at the top left of the display. Either Porsche or workshop appears in the center, depending on where the setting was made. The asterisk at the right appears if the setting "remote control on light flashing" has been selected.
To select a setting, press key 1:
Indicated on display
1 = on
2 = flash. lights on
3 = off
return: N
The settings which are available are displayed. To make the setting, press the appropriate key.
NOTE: If the setting "remote control flashing lights on" is selected, the lights flash twice as confirmation after the vehicle has been locked.
After the vehicle has been unlocked, the lights flash once.
As this status indication is not permitted in some countries. The alarm system should be set in accordance with the C number, as indicated above.