Cellular Phone: Service Precautions

General instructions/safety instructions
The following points must be observed during vehicle diagnosis:
- After the battery is connected, volatile memories must be re-programmed. In the case of radio coding and tuning, the customer must be informed of decoding and the deleted tuner memory.
- After the battery has been connected, the instructions in the assembly - work instructions after disconnecting the battery must be observed.
- Deactivate the 'automatic traffic announcement' before beginning the diagnosis on the PCM2. If this is not done, the system will crash (valid only for software version < 03).
- When working on the optical waveguide, please observe the instructions in assembly - Optical waveguide - MOST bus.
- After troubleshooting or repairs, erase the fault memory with the 9588 Porsche System Tester II and carry out a test drive
- After the test drive, read out the fault memory again with the 9588 Porsche System Tester II

DANGER:
Danger of injury through triggering of driver's airbag
- Never hang the 9588 Porsche System Tester" overthe steering wheel.

CAUTION:
Danger of damage due to improper handling of the battery and control module connectors.
- Never disconnect battery with engine running.
- Never start engine unless battery is connected securely.
- Never pull off or push on plug connections for the control modules or other electronic components when the ignition is switched on.