Procedures

Removing and installing headlights

- The tool kit contains a wrench for unlocking and locking the headlights.
- When installing, press headlights firmly into the fender.
- Insert plugs after installation.

NOTE:
- Risk of damage to headlights due to chafing and excessive temperatures.
- Headlights must not be covered when they are switched on, e.g. fender protection or film.




1. Release the side carpet by unscrewing plastic nut, arrow A .




2. Pull rubber stopper B off the release opening.




3. Place the socket wrench from the tool kit on the release axle.
4. The toggle of the socket wrench should point horizontally to the rear.
5. Turn the socket wrench through approx. 180 degrees (arrow A) and leave it in position.
6. The headlight is now unlocked and can be pulled forwards out of the fender.
7. Turn the socket wrench back until it points vertically (arrow B) downwards.

Installing main headlight

NOTE: Do not attach any covers (e.g. stone shields or films) in the area of the headlights.




1. Insert the headlight into the guide rails and push it fully into the fender (arrow).
2. Press the headlight to the rear, turning the socket wrench at the same time until the wrench points horizontally to the rear (arrow C). In the process, the headlight lock must engage with an audible and perceptible click.
3. Check the correct seating of the headlight, e.g. by pulling gently in the area of the fog light.




4. Insert rubber stopper in the release opening.




5. Screw the side carpet tight with the plastic screw A.