Replacing Fusible Element In the Current Distributor

Removal
1 Remove current distributor as described up to step 4 in Replacing the Current Distributor.
2 After removing the outer lid, remove the inner lid. To do this, sever the tour locking tabs by inserting a small screwdriver through the opening slots.







3 Take off inner lid and remove the severed locking tabs.
4 Remove the blown fusible element. Remove M 5 hexagon nuts and intermediate layers together with the blown fusible element. These parts must not be used again.







Installation
1 Install new fusible element. The new fusible element and the new intermediate layers and M 5 fastening nuts are contained in the original repair kit "Fusible element".
2. Install new original fusible element, intermediate layer and M 5 hexagon nut and tighten.
Tightening torque 3.5 Nm (2.5 ft lb.)
3 The blue service inner lid is engaged after installation.
4 Engage the outer lid and seal with two service labels (red).
5 Install current distributor as described from step 4 in Replacing the Current Distributor.

Free connection point in the current distributor

NOTE: The free connection point (F 7) in the current distributor is protected by a 50 A fusible element. No additional loads must be connected to this free connection point (F 7).