7.5.1 - Pressure Adaptation Values

The required values for pressure adaptation are given in the following table. The stored adaptation valves are lost if the power supply to terminal 30 is interrupted. Shift quality may worsen during the teaching phase of the transmission control system. If the actual values are in the upper range, this could signify transmission damage.

Tester display Required value
1-2 shift, lower rpm range -0.7 to 1.0 bar
1-2 shift, middle rpm range -0.7 to 1.0 bar
1-2 shift, upper rpm range -0.7 to 1.0 bar
2-3 shift, lower rpm range -0.7 to 1.7 bar
2-3 shift, middle rpm range -0.7 to 1.7 bar
2-3 shift, upper rpm range -0.7 to 1.7 bar
3-4 shift, lower rpm range -0.7 to 1.4 bar
3-4 shift, middle rpm range -0.7 to 1.4 bar
3-4 shift, upper rpm range -0.7 to 1.4 bar
4-5 shift, lower rpm range -0.7 to 1.0 bar
4-5 shift, middle rpm range -0.7 to 1.0 bar
4-5 shift, upper rpm range -0.7 to 1.0 bar
5-4 shift, lower rpm range -0.7 to 0.8 bar
5-4 shift, middle rpm range -0.7 to 0.8 bar
5-4 shift, upper rpm range -0.7 to 0.8 bar
2-1 shift, lower rpm range -0.7 to 0.8 bar
2-1 shift, middle rpm range -0.7 to 0.8 bar
2-1 shift, upper rpm range -0.7 to 0.8 bar