Accelerator Pedal

Removing and Installing Accelerator Pedal

Removal

1. Pull off the centre air duct (A) in the driver's footwell.







2. Undo upper countersunk screw (M5 x 55) on the accelerator pedal and remove the accelerator pedal.







3. Disengage electrical plug connection on the bracket. To do this, turn the plug connection counterclockwise in the bracket and take it off. Disconnect plug connection.
4. Undo two hexagon nuts (a/f 10 mm) on the pedal encoder.







5. Pull pedal encoder out of the stud, disengage cable from the cable disc and remove the pedal encoder in downward direction.
6. Press both locking tabs of the cable guide together by hand and simultaneously pull the cable out of the bracket


Installation

1. Engage cable guide into the bracket. Then pull slightly to ensure that the connection is properly locked.
2. Fasten the accelerator pedal.
Tightening torque of the countersunk screw (M5 x 55) 2.8 Nm ± 10 % (2.0 ftlb. ± 10 %)
3. Engage cable in the cable disc, insert the pedal encoder in the stud and fasten with two hexagon nuts.
Tightening torque 8 - 9 Nm (6.0 - 6.5 ftlb).







4. Fit air duct.