Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (This is the last day we'll be asking)

Crankshaft Position Sensor: Service and Repair

Removal
1. Remove right rear wheel.
2. Disconnect plug connection; to do this, press the clip and simultaneously pull off the plug.
Pull the lower plug half out of the holder to the right.

3. Unclip cable (arrow 1).
Undo M6 x 16 pan-head screw (arrow 2) (wrench size 4 mm) and remove the pulse sender.

Installation
1. Install pulse sender.
Tightening torque of the pan-head screw (M6x16): 10 ± 0.5 Nm (7.5 ± 0.5 ft. lbs.)
2. Push in lower plug half on the holder.
3. Push plug on until it audibly engages.