Initial Inspection and Diagnostic Overview

General instructions / safety instructions
The following points must be observed during vehicle diagnosis:
- After the battery is connected volatile memories must be reprogrammed. In the case of radio coding and tuning, the customer must be informed of decoding and the deleted tuner memory.
- The coding, calibration and headlight adjustment must be observed after an HBA control module or an angle sensor for HBA has been replaced or the running gear has been modified.
- After troubleshooting or repairs, erase the fault memory with the Porsche System Tester 2 and carry our a test drive.

After the test drive, read out the fault memory with Porsche System Tester 2 again.


CAUTION!
Danger of damage due to improper handling of the battery and the control module connectors.


> Never disconnect battery with engine running.
> Never start engine without securely connected battery.
> Never pull off or push on plug connections of the control modules or other electronic components when the ignition is switched on.