Horn: Service and Repair

Removing and installing horn





NOTE: Both horns are fastened on a bracket on the right front side between the body and condenser.


Removal






1. The high-pitch horn can be removed from below through the sound outlet opening. Pull off electrical plug connection and observe installation position of the horn.
2. Unscrew the M 6 hexagon nut from the bracket and remove the high-pitch horn through the sound outlet opening.

NOTE: The entire front end must be removed in order to remove the low-pitch horn.

Installation
1. Observe installation position of the horns. The horn must not touch the body or a bracket.
2. A toothed washer must be fitted between the horn and bracket.

Tightening torque of the M6 hexagon nut 10 Nm (7.5 ft lb.)