Calibrating Fuel Level Sensor System

Calibrating Fuel Level Sensor System

WARNING:
Danger of fire and injury.
- Observe general safety regulations on the fuel system.
- Wear protective gloves.

INFORMATION: Calibration is necessary after replacement of the fuel tank, fuel level sensor or instrument cluster.

1. Disconnect the battery and cover terminal and battery. Remove cap over the fuel level sensor system.
2. Remove fuel level sensor (Removing fuel pump).
3. Using a fuel extractor, completely drain the fuel tank through the fuel level sensor opening. Fuel extractor:.
4. Make sure that the two recesses on the left and right-hand sides of the tank are emptied completely.
5. Reinstall the fuel level sensor and, with "ignition off", fill the tank with 28 liters of fuel. The indication in the Porsche System Tester 2 (old or new characteristic) is the decisive indication.
6. Perform tank calibration with the Porsche System Tester 2.
- Select vehicle type (911 Carrera)
- Select control units
- Select instrument cluster
- Select menu item "Tank calibration"
- Confirm calibration

The fuel level sensor system has now been calibrated.

INFORMATION:
- The fuel level sensor system need not be calibrated if the battery was disconnected or a plug connection on the instrument cluster or fuel level sensor was removed. The values remain stored in the instrument cluster.
- A range on remaining fuel of less than 15 km is not displayed in the instrument cluster.