Removing and Installing Rear Side Section Flap

Removing And Installing Rear Side Section Flap



















Adjusting The Gap Dimensions Of The Rear Side Section Trim

Adjusting the rear side section trim







(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The height adjustment is made using the Torx screws -D1- in the flap.
- Set the gap dimension -D- rear side section flap to the side trim panel.
- Set the gap dimension -E- rear side section flap to the side trim panel.
- Set the gap dimension -F- rear side section flap to frame trim panel for the roll-over protection system.

Test And Adjusting Values







NOTE: Illustration of the gap dimensions.