Programming The New DME Control Module

Programming The New DME Control Module - GT2

NOTE:
- If a new DME control module is to be installed in a vehicle, the DME code specified in IPAS and the immobilizer code must be entered in the DME control module.
- You can get the codes from IPAS or from your importer by specifying the vehicle identification number.
- In the case of the GT2, a 32-figure Key 1 code is displayed in the Porsche System Tester (see Point 12); in addition, a Key 2 code is required (see Point 15) in order to be able to transfer the data status required for this vehicle type.
- During DME programming, it is essential to guarantee the power supply for the Porsche System Tester. In case of doubt, connect a charging unit to the car battery.
- Determine the Key 2 code by following the described procedure and finish with [>>]. After receiving the Key 2 code, begin again at Point 1.
- It is possible to program a GT2 DME control module as from Porsche System Tester Version 11.1.
- Symbol for the TAB key = [-->|]
- Follow the instructions for the Porsche System Tester.

1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on.
2. Select vehicle type -GT2- using the cursor keys.
3. Using the [-->|] key, move from the vehicle type to the list of control modules.
4. Select DME with the cursor keys and press the [>>] key.
5. Select "Control unit programming" with the cursor keys and press the [>>] key.
6. Select "Control unit programming" with the cursor keys and press the [>>] key. Follow the displayed programming instructions from the Porsche System Tester.
7. Enter the Veh. Ident. No. with the cursor keys and confirm.
8. Enter the new DME (IPAS) programming code and confirm with the [>>] key.
9. Check the DME programming code again; if the code is correct, confirm with the F7 key.
10. Enter the new immobilizer code (IPAS), check it again and confirm with F7.
11. Select the required program map and confirm with the [>>] key
==>Refer to "Version (data records) - GT2".
12. With the GT2, a Key 1 code is displayed in the Tester, which is automatically stored in the release protocol.
13. With the [ALT] key (Hard copy), move into the Printer menu, select the release protocol and print it out.
14. The name and telephone number of the contact person must be noted on the release protocol. Fax the protocol to Porsche AG, Dept. VAC1, fax no. 0049/711/911-8570.
15. A Key 2 code is then delivered to you by Dept. VAC1. Enter the Key 2 code with the cursor keys, continue with the [>>] key and, after checking the Key 2 code, confirm it with the F7 key.
16. The data and programming status is then loaded on to the DME control module. Do not interrupt the programming sequence.
17. When the programming period has expired, follow the instructions from the Porsche System Tester -CAN TIME OUT-.
18. Press the [>>] key. For the learning and adaptation routine of the throttle (E-gas), switch the ignition on for 1 minute without starting the engine and without actuating the accelerator pedal. Then switch the ignition off for at least 10 seconds. This completes the adaptation of the throttle adjusting unit and the programming sequence is complete.
19. Read out the fault memory and delete the fault -CAN TIME OUT- on every control module that is connected to the CAN.