Operation CHARM: Car repair manuals for everyone.
Home >> Porsche >> 2004 >> 911 Carrera 4S Cabriolet (996) F6-3.6L >> Repair and Diagnosis >> A L L Diagnostic Trouble Codes ( DTC ) >> Testing and Inspection >> Manufacturer Code Charts >> Instrument Panel, Gauges and Warning Indicators >> Instruments, Fuel Gauge, Alarm System >> Fault Code 9101

Fault Code 9101



Fault Code 9101

CAN drive bus

Diagnostic conditions
- Ignition on

Possible cause of fault
- Short circuit between the two CAN leads (CAN-high and CAN-low)
- Short circuit between CAN-high (drive) and ground
- Short circuit between CAN-low (drive) and voltage
- A faulty control module connected to CAN drive bus

NOTE:
- The CAN drive bus is connected to the following control modules.
- DME
- Tiptronic
- PSM and steering angle sensor
- Instrument cluster
- The plug connections of control modules connected to the CAN drive bus are disconnected for troubleshooting. This causes additional CAN-relevant fault codes, e.g. "9110 DME control module", to be stored in the fault memory of the instrument cluster. These fault codes should be initially ignored and should be deleted on completion of the troubleshooting.

Affected pins
Instrument cluster connector A, pin 15 and pin 31

Diagnosis/troubleshooting


Diagnosis/troublestooting (Part 1):




Diagnosis/troublestooting (Part 2):




pro multis · About Operation CHARM