Ultrasonic Sensor: Service and Repair

Removing and installing passenger compartment monitoring sensor

Removal






1. Using a small screwdriver, carefully unclip both cover lenses at the openings provided. Undo M 6 (Torx T30) fastening screws.
2. Remove locking hook holder and pull off electrical plug connections.






3. Unclip passenger compartment monitoring sensor at the side and remove from the locking hook holder.


Installation

1. Do not press on or touch the transmission/reception diodes with your fingers.

2. Engage electrical plug connections and route wire carefully (do not pinch).

Tightening torque:
M6 fastening screws 10 Nm (7.5 ft lb.)

3. The cover lenses must not be soiled or smudged with grease.
Clip in cover lenses again.