Differential Mount: Service and Repair

Removing and installing support for final drive





A Support for final drive
B Fastening screws

Removal
1. Remove final drive.
2. Unscrew fastening screws and remove support.

Installation





1. Fit support in the correct position (angled side facing upwards).

Note!
^ At the beginning of the series, supports with tabs were installed. These supports must be fitted with the tabs facing downwards.

A Tabs





2. Tighten fastening screws in two stages.
1st stage: Screw both screws to 5 Nm (3.7 ft. lbs.).
2nd stage: Tighten both screws to 65 Nm (48 ft. lbs.).
3. Install final drive.