Headlamp: Adjustments

941519 Removing And Installing Main Headlight

NOTE:
Risk of damage to headlights due to chafing and excessive temperatures.
- Headlights must not be covered when they are switched on, e.g. wing protector or film.
- Switch off the ignition.

Releasing carpet at the sides:

1. Release carpet at the side by unscrewing plastic nut -A, arrow-.

Rubber stopper:

2. Pull rubber stopper -B- out of the release opening.

Release the headlight:

3. Place the socket wrench from the tool kit on the release axle.
4. The toggle of the socket wrench should point horizontally to the rear.
5. Turn the socket wrench through approx. 180° -A- and leave it in position.
6. The headlight is now unlocked and can be pulled forwards out of the wing.
7. Turn the socket wrench back until it points vertically -B- downwards.

Installing main headlight

NOTE:
- Risk of damage to headlights due to chafing and excessive temperatures.
- Headlights must not be covered when they are switched on, e.g. wing protector or film.
- Switch off the ignition.

1. Insert headlight into guide rails and push fully home into wing -arrow-.

Lock headlight:

2. Press the headlight to the rear, turning the socket wrench at the same time until the wrench points horizontally to the rear -arrow C-. In the process, the headlight lock must engage with an audible and perceptible click.
3. Check the correct seating of the headlight, e.g. by pulling gently in the area of the fog light.

Rubber stopper:

4. Insert rubber stopper -B- in the release opening.
5. Screw the carpeting at the side tight with the plastic screw -A-.