681219 Removing And Installing Lid For Glove Compartment

Removing And Installing Lid For Glove Compartment






Removing lid for glove compartment









Installing lid for glove compartment









Replacing microswitch and interior light

NOTE: In the case of a defective microswitch, the complete wiring harness -4- must be replaced!

1. Replacing microswitch and interior light






1.1. Refer to Removing and installing glove compartment
1.2. On the retaining bracket -2-, press the locking tabs -A- apart. Guide out the microswitch -5-.
1.3. Insert a plastic spatula into the side of the interior light -1- and press out. Disconnect the electrical plug connection.
1.4. 2 - Installing microswitch and interior light
1.5. Plug in the electrical plug connection of the interior light -1-. Press the interior light -1- into the cut-out of the glove compartment.
1.6. Press the microswitch -5- into the retaining bracket -2-. Note the coding of the microswitch.
1.7. To fit the glove compartment, engage the electrical lead -4- into the clip -3-.
1.8. Refer to Removing and installing glove compartment

Replacing pneumatic shock absorber

1. Removing the pneumatic shock absorber






1.1. Press the pneumatic shock absorber -1- out of the fastening tab -arrow B-.Turn the pneumatic shock absorber by 90° anti-clockwise in the direction of arrow -A- and guide it out of the glove compartment.
1.2. 2 - Installing the pneumatic shock absorber
1.3. Insert the pneumatic shock absorber -1- and turn it 90° clockwise in the direction of arrow -A-. Insert the pneumatic shock absorber into the fastening tab towards the -direction of arrow B-.