Camshaft Position Sensor: Service and Repair

Removing And Installing Hall Sender

Preliminary work
1. Remove intake-air distributor.

Removing hall sender

NOTE:
- The hall sensors are located behind the camshaft housing and point towards the intake system.
- Replace all seals and O-rings.

1. Disconnect connector on hall sender. To do so, push the button and remove.







2. Loosen the fastening screw on the hall sender. Use a socket wrench with 1/4 inch drive and a joint.
3. Pull the hall sender out of the camshaft housing.

Installing hall sender







1. Push the hall sender into the camshaft housing and tighten the fastening screw. Tightening torque 7.5 ft.lb.
2. Push on electric connector. The connector must engage audibly.

Subsequent work
1. Install intake distributor.