Fault Code 0105

Fault code 0105

Driver's door lock (feedback)

NOTE: This fault was detected by the 'driver's door' control module.

Diagnostic conditions
- Ignition on
- Battery voltage OK (11.4 to 14.5 V)
- Internal function test on driver's door control module
- The door lock in the driver's door must assume all possible statuses (unlocked, locked, secured).

Possible causes of fault
- Driver's door lock faulty
- Wiring faulty

Affected pins
Driver's door control module, plug C:
- Pin 1 'central locking, terminal 31'
- Pin 3 'central locking, Safe status'

Diagnosis/troubleshooting

NOTE:
Visual inspection: In the next troubleshooting section, please check first that the affected pins on the driver's door control module plug connection are neither damaged nor corroded. The wiring and plugs of the affected components must also be checked for external damage and correct contacts. Repair damaged or corroded pins if possible, otherwise replace affected pins. Repair or replace damaged wires.

NOTE:
Sporadic faults: In the event of faults that occur sporadically, the wiring positions that are linked to moving parts on and in the vehicle must be checked for each system. Various statuses that can cause faults must be simulated with the help of the wiring diagram.

NOTE:
Battery voltage: A battery voltage of between 11.4 and 14.5 V is required for the following troubleshooting procedure. This must be checked and provided, if necessary. On the vehicle electrical system, the voltage to the fuse (input side) must be guaranteed.

NOTE: 'Implausible signal' --> This fault is detected if the resistance between plug C, pins 1 and 3 is between 230 Ohms and 3,000 Ohms.