Transfer Box

Fault code 1317

Instrument cluster

Diagnostic conditions
- Ignition on
- Internal control module function test

Possible cause of fault
- Signal from instrument cluster does not correspond to expected signal (please read out fault memory).
- Signal from instrument cluster does not appear on CAN drive (no signal/communication).

Affected pins
Transfer box control module plug:
- Pin 11 'CAN drive (low)'
- Pin 42 'CAN drive (high)'

Diagnosis/troubleshooting VG 0101

NOTE: If there is no incoming signal/message via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to 'Checking instructions/CAN data bus'.